2

Ubiquiti airFiber 11 High-Band Backhaul Radio with Dish Antenna vs Ubiquiti airFiber 5 Mid-Band Karşılaştırma

En fazla 4 ürün. Ürün kartlarından veya ürün sayfasından «Karşılaştır» ile ekleyin.

Seçili (2/4) Ubiquiti airFiber 11 High-Band Backhaul Radio with Dish Antenna × Ubiquiti airFiber 5 Mid-Band ×
Tümünü temizle

Özellik karşılaştırması

Özellik Ubiquiti airFiber 11 High-Band Backhaul Radio with Dish Antenna Ubiquiti airFiber 5 Mid-Band
Kategori Kablosuz Kablosuz
Model AF11-Complete-HB AF-5
Fiyat Fiyat ve stok sorunuz Fiyat ve stok sorunuz
Stok Stokta Tükendi
Boyutlar 811 x 811 x 460 mm (31.9 x 31.9 x 18.1") 938.4 x 468.4 x 281.4 mm (36.9 x 18.4 x 11.1")
Ağırlık Without mount: 7.14 kg (15.74 lb)With mount: 11.85 kg (26.12 lb) 16 kg (35.3 lb)
Montaj Pole mount Pole mount kit (Included)
Networking interface (1) GbE RJ45 port(1) 10/100 MbE RJ45 port (1) GbE RJ45 port(1) 10/100 MbE RJ45 port
Power method Passive PoE 4-pairs (1, 2+; 3, 6-) (4, 5+; 7, 8-)Terminal block direct-wire Passive PoE 4-pairs (1, 2+; 3, 6-) (4, 5+; 7, 8-)
Power supply 50V DC, 1.2A gigabit PoE adapter (Included) 50V, 1.2A gigabit PoE adapter (Included)
Supported voltage range 38-56V DC 42–58V DC
Max. power consumption 36W 40W
RF connectors (4) SMA Weatherproof, Two per Chain: TX 0, RX 0 (Chain 0) and TX 1, RX 1 (Chain 1)(2) N-Type Waterproof, One per Duplexer —
Ambient operating temperature -40 to 55° C (-40 to 131° F) -40 to 55°C (-40 to 131° F)
Sertifikalar CE, FCC, IC CE, FCC, IC
NDAA Compliant Yes Yes
Modes SISO/MIMO** Comes with (1) High-Band Duplexer pre-installed for SISO mode. For MIMO mode, a second Duplexer is available, model AF-11-DUP-H. —
Max. throughput 1.2+ Gbps 1.2+ Gbps
Max. range 300+ km —
Encryption 128-bit AES 128-Bit AES
Operating frequency* 10.7-11.7 GHz*Depends on regional regulations. —
Max. conducted TX power* 30 dBm*Depends on regional regulations. —
Frequency accuracy ± 1 ppm ±2.5 ppm without GPS synchronization±0.2 ppm with GPS synchronization
Channel bandwidth* 3.5/5/7/10/14/20/ 28/30/40/50/56 MHz selectable**Programmable Uplink and Downlink duty cycles* For region-specific details, refer to the Compliance chapter of the airFiber AF-11FX User Guide at ui.com/download/airfiber**Channel widths may vary according to country/region regulations. —
Wind loading 1538 N @ 200 km/h (346 lbf @ 125 mph) 863 N @ 200 km/h (194 lbf @ 125 mph)
Wind survivability 200 km/h (125 mph) 200 km/h (125 mph)
Frekans 10.3 to 11.7 GHz —
Gain 35 dBi —
HPOL beamwidth 2.5° —
VPOL beamwidth 2.5° —
Maximum VSWR 2:1 —
Polarization Default: H/VAfter rotating OMT: ± 45° Dual-slant
Cross-pol isolation 35 dB —
Pattern regulatory ETSI 302 217-4-2, Class 3, FCC Cat B —
Auxiliary port — (1) RJ-12, alignment tone port
Max. range* — 100+ km*Dependent on regulatory region.
Packets per second — 1+ million
Uplink/downlink ratio — Programmable in Half Duplex mode
Radio frame synchronization — GPS
Operating frequency — 5470 - 5600 MHz, 5650 - 5850 MHz (FCC 15.247, 15.407, IC RSS 210)5470 - 5875 MHz (ETSI EN 301 893, EN 302 502)5470 - 5950 MHz (Other regions)
GPS — GPS clock synchronization
EIRP — ~50 dBm*Dependent on regulatory region and frequency band.
Channel bandwidth — 10/20/30/40/50 MHz
Modulation — 1024QAM MIMO256QAM MIMO64QAM MIMO16QAM MIMOQPSK MIMO½ Rate QPSK xRT¼ Rate QPSK xRT
GainTXRX — 23 dBi23 dBi
Beamwidth — 6°
Front-to-back ratio — 70 dB
Cross-polarity isolation — > 28 dB
System — (12) Status LEDs: Data port pink/activityData port speedManagement port link/activityManagement port speedGPS synchronizationMaster/slaveLink statusModulation mode 0.25x to 4x, 6x, 8x, 10x (unlabelled), overloadRemote and local displays (Calibrated signal strength)
Proje için teklif al Toplu alım isteği Kurulum desteği

Ürün ekle

Listeye en fazla 4 ürün ekleyebilirsiniz. Aynı kategoriden öneriler:

Ürünlere göz at